Bug Fixes

This document lists the bugs fixed in version release 20230505.

ISSUE INTERNAL REF. 200017

Description: Blade 3 cannot connect to internet because system cannot resolve DNS

Workaround: Run the following commands to make the system resolve DNS.

sudo mv /etc/resolv.conf /etc/resolv.conf.original

sudo ln -s /run/systemd/resolve/stub-resolv.conf /etc/resolv.conf

sudo systemctl restart systemd-resolved.service

systemctl enable systemd-resolved.service

Keywords: internet, DNS

Discovered in Version: 20230214

Description: Failed to update firmware with a MicroSD card when Blade 3 was powered via USB1/PD Type-C port

Workaround: Use 12 V power input via U.2 port

Keywords: update firmware, MicroSD card

Discovered in Version: 20230214

Description: When powered via USB1/PD Type-C port, Blade 3 failed to start up after firmware update in MaskROM mode

Workaround: Select any of the following methods:

Use a PD power adapter that only outputs 9 V 2 A power
Use 12 V power input via U.2 port
Do not connect Blade 3 to any display upon first start-up and wait for 5 minutes. Then it will finish the update and work normally

Keywords: update firmware, MaskROM

Discovered in Version: 20230214

Description: Failed to boot Blade 3 from MicroSD card when Blade 3 was powered via USB1/PD Type-C port

Workaround: Select any of the following methods:

Use a PD power adapter that only outputs 9 V 2 A power

Use 12 V power input via U.2 port

Keywords: Boot up, MicroSD card

Discovered in Version: 20230214

Was this article helpful?